Wmt-3000 Manual indd



Download 27.81 Kb.
View original pdf
Page2/6
Date24.02.2019
Size27.81 Kb.
1   2   3   4   5   6
PIR settings (figure 1)
The jumpers settings areas follows:
Range: High feet
Medium- 50 feet
Low- 30 feet
LED: ON- led will flash when it detects
OFF- led is always dark
Filter: Onset for outdoor use
Off-set for indoor use
Reset: 15 seconds to reset after activation seconds to reset after activation
Coding the transmitter:
Note: The transmitters and receivers are preset
at the factory. DO NOT change settings, unless
changing the tune or experiencing false sig-
nals.
1. When looking at the PIR you will see clips on the sides of the plastic case. Push one of the clips away from the center of the case and lift out the PIR and the plastic backing. You will now be looking inside of the case at the radio transmitter (figure Figure 1
PIR with cover removed


{
{
4
3
figure 2 4.
2. Locate the dip switches in the WMT-3000 transmitter module (figure 2).
3. The first eight dip switches are for the frequency setting (256 combinations. Set switches 1-8 (3) to match the eight switches in the receiver.
4. Switches 9 and 10 (4) are for the zone/channel settings on the transmitter. The four zones are listed in the table below.
Switch Switch
10
Channel
12-volt DC output
Tune
On
On
1
Yes
Classical
Off
On
2
No
Westminster
On
Off
3
No
Ding Dong
Off
Off
4
No
Whistle


Wmt-3000wireless
Low battery alert
Coding the receiver:



Share with your friends:
1   2   3   4   5   6


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha