2. Select the mode with the MODE knob. * When MOMENTARY is selected, the CHECK indicator light goes off, and the effect is switched off. Hold the pedal down when using the following settings in MOMENTARY mode (the effect is on only while the pedal is depressed). 3. Set the flanging rate with the RATE knob. 4. Set the sweep depth with the DEPTH knob. 5. Set the center frequency to which the effect is applied with the MANUAL knob. 6. Turn the RES knob to set the strength of the effect. 4 6 3 2 5
11 Setting the RATE by Inputting the Tempo with the Pedal Switch When Switching to Tempo Input with the Effect ON (CHECK indicator Red) * RATE cycles for use with the tempo settings can be made in the range of 0.1–18 seconds. fig.06 * If you carryout Step immediately after Step , Step may inadvertently be interpreted as tempo input, thus changing the RATE setting. Allow a brief interval to pass before progressing from Step to Step . * If you adjust the RATE knob after completing the settings, the effect then reflects the position of the RATE knob. * You cannot input the tempo in MOMENTARY mode. Off Off Red Red Red/Green Blinking Effect synchronized to tempo Off On On 1 Press the BF-3’s pedal switch in timing with the tempo.