USING CURVED + FLAT ADHESIVE MOUNTS The Curved + Flat Adhesive Mounts make it easy to attach the camera to curved and flat surfaces of helmets, vehicles, and gear. Using the Quick Release Buckle, the assembled camera housing can be clicked on and off the secured Curved or Flat Adhesive Mounts. Flat Adhesive Mount Curved Adhesive Mount Slim housing surfboard mount installation Slim housing remove camera Slim housing insert camera Slim housing closed Swapping housing doors Quick Release Buckle + Thumb Screw + Slim housing = Complete Unit Using the Mounts MOUNTING GUIDELINES Follow these guidelines when attaching mounts: • Attach the adhesive mounts at least 24 hours before use. Allow 72 hours for complete adhesion. • Adhesive mounts must be mounted only on smooth surfaces. Porous or textured surfaces do not enable a proper bond. When applying the mount, firmly press it into place and ensure full contact over the entire surface. • Apply adhesive mounts to clean surfaces only. Wax, oil, dirt, or other debris reduce adhesion, which can result in a weak bond and risk of losing the camera should the connection fail. • Attach adhesive mounts in room temperature conditions. Adhesives do not bond properly if applied in cold or damp environments to cold or damp surfaces. For more information on mounts, visit gopro.com/support. WARNING: If using your camera with a GoPro helmet mount orb bstrap, always select a helmet that meets the applicable safety standard. Choose the right helmet for your particular sport orb bactivity and make sure that it is the right fit and size for you.