User Guide mds86825slr ultra-Light Rollator



Download 52.54 Kb.
View original pdf
Page5/8
Date06.01.2019
Size52.54 Kb.
1   2   3   4   5   6   7   8
Front Wheel Assembly
1. When inserting front wheel make sure FRONT sticker is pointed toward the front and away from rollator (see Figure A).
2. Insert wheel to desired height depicted by numbered holes (set to the same number as rear wheels).
3. Place triangular hand screw into hole. Make sure triangular hand screw stays outside of rollator frame (see Figure B).
4. Tighten triangular screw
(Important: Hand Tighten Only!)
until secure
(see Figure C).
5. Repeat steps 1-4 for other front wheel.
Figure A
Figure B
Figure C


To determine proper height, stand upright behind the rollator with shoulders relaxed, arms hanging at your side and eyes looking straight ahead. Standing in current position, the hand grips (A) of the rollator should be adjusted to a height even with the wrists. This will position the arms at an approximated 20 to 30 degree bend when using the rollator. Secure the wheels to the closest hole to the desired height. Insert and tighten the triangular hand screws until secure.


User guidemds86825slr
Ultra-light rollator features
Assembly instructions
Rear wheel assembly
Hole 1hole 2



Share with your friends:
1   2   3   4   5   6   7   8


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha