User Guide M211095en-h


START command. To stop measurement, use theSTOP



Download 8.38 Kb.
View original pdf
Page87/125
Date24.02.2019
Size8.38 Kb.
1   ...   83   84   85   86   87   88   89   90   ...   125
START command. To stop measurement, use the
STOP command SDI Commands
You can only use COM serial port for sending commands and receiving data messages with the SDI profile.
The following table lists the available commands for operating WMT700 with SDI profile.
Table 56 SDI Commands
Command
Description
?!
Queries WMT700 for its address.
a!
Ensures that WMT700 is responding.
aI!
Queries WMT700 for its SDI compatibility level, model number, and firmware version number.
aAb!
Changes WMT700 address.
Chapter 5 – Operation
153


Command
Description
aC!
Starts concurrent measurement.
aCC!
Starts concurrent measurement with CRC calculation.
aD0!
Fetches instant data from WMT700.
aM!
Starts measurement.
aMC!
Starts measurement with CRC calculation.
aV!
Starts verification.
The following SDI commands cannot be used with WMT700:
• Measurement Unit Change Command


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   83   84   85   86   87   88   89   90   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha