User Guide M211095en-h



Download 8.38 Kb.
View original pdf
Page82/125
Date24.02.2019
Size8.38 Kb.
1   ...   78   79   80   81   82   83   84   85   ...   125
Command
Description
I
Requests identification information for WMT700.
Wx
Starts measurement based on averaging time and fetches the data.
You cannot use the WS425 AB ASCII command Measurement Unit Change
Ux with
WMT700. Fora list of configuration commands for WMT700, see A. Command Set for
WMT700 (page 181)
5.24.1.1 I — Identify Sensor
This command shows the vendor, model number, and version information of WMT700.
I
WMT700 User Guide
M211095EN-H
148


VAISALA WMT700 200 5.24.1.2 Wx — Start Measurement
This command starts wind measurement based on averaging time and fetches the data automatically when the measurement has finished. You must specify the averaging time in the command.
The averaging time supplied in the command (
x) sets the averaging time for WMT700.
When you change the averaging time, it applies to the next new wind value.
Wx x
Time for averaging wind speed and wind direction. The range is from 1 to 9
WMT700 responds to the


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   78   79   80   81   82   83   84   85   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha