User Guide M211095en-h



Download 8.38 Kb.
View original pdf
Page54/125
Date24.02.2019
Size8.38 Kb.
1   ...   50   51   52   53   54   55   56   57   ...   125
Item
Description
\01
SOH (start of heading)
\02
STX (start of text)
\03
ETX (end of text)
\04
EOT (end of transmission)
\cr
CR (carriage return)
\lf
LF (line feed)
\se
Checksum calculation endpoint spPrint checksum
\ss
Checksum calculation start point
Table 42 Monitoring Items for Data Messages
Item
Description
\er
Status code. The code is a decimal number. Each bit corresponds to a status flag. Fora list of the bits, see
5.9.2 Status Flags (page 113)
\fb
0 = No error = Blocked sensor
\fh
0 = No error = Heater failure. Incorrect heater resistance.
\fs
0 = No error = Wind speed exceeds operating limits = Sonic temperature exceeds operating limits = Wind speed and sonic temperature exceed operating limits
\ft
This value indicates temperature sensor failures when converted to binary format:
Bit 0 = Temperature sensor 1 failure
Bit 1 = Temperature sensor 2 failure
Bit 2 = Temperature sensor 3 failure
Chapter 5 – Operation
111




Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   50   51   52   53   54   55   56   57   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha