User Guide M211095en-h


STARTcommand.More Information



Download 8.38 Kb.
View original pdf
Page51/125
Date24.02.2019
Size8.38 Kb.
1   ...   47   48   49   50   51   52   53   54   ...   125
START
command.
More Information
‣ Configuration Parameter Descriptions (page Upgrading from WS425 to WMT700 (page Loading Settings from Configuration Files (page START — Start Continuous Measurement (page 106)
5.9 Configurable Data Messages
You can define new data messages for automatic messaging or polling with the WMT700
profile. Each item in a user-configurable data message string consists of 2 characters after the \ character. For example, the item for wind speed is
\ws. The maximum number of characters fora string is The characters are passed to messages as they are. All visible ASCII characters are allowed,
except the available items for data message strings listed in Table 40 (page Chapter 5 – Operation
109

You can only use the user-configurable data messages with the WMT700 protocol.


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   47   48   49   50   51   52   53   54   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha