User Guide M211095en-h



Download 8.38 Kb.
View original pdf
Page5/125
Date24.02.2019
Size8.38 Kb.
1   2   3   4   5   6   7   8   9   ...   125
More Information
‣ Configuration (page 101)
2.3.1 Measurement Range
Ordering option 1 defines the wind speed operation range. The maximum reported value of wind speed 40, 65, 75, or 90 ms, depending on the selected option. Accredited Wind
Calibration according to Measnet procedure.
Table 5 Measurement Ranges of Different Sensor Types
Sensor Type
Measurement Range
1
WMT701 up to 40 m/s
2
WMT702 up to 65 m/s
3
WMT703 up to 75 m/s
4
WMT704 up to 90 m/s
A
WMT701 up toms+ Accredited Wind Calibration
B
WMT702 up toms+ Accredited Wind Calibration
C
WMT703 up toms+ Accredited Wind Calibration
D
WMT704 up toms+ Accredited Wind Calibration Temperature Range
Ordering option 2 defines the operating temperature range for the sensor.
Table 6 Temperature Range


Document code
Testsetup according to
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
More information
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   2   3   4   5   6   7   8   9   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha