User Guide M211095en-h



Download 8.38 Kb.
View original pdf
Page47/125
Date24.02.2019
Size8.38 Kb.
1   ...   43   44   45   46   47   48   49   50   ...   125
More Information
‣ Configuration Parameter Descriptions (page ERRORS — Get Error Codes and Counts (page 106)
5.4.2 G — Get Parameter
The
G command shows the values of the configuration parameters. You can either display all parameter values or only certain values.
More Information
‣ Configuration Parameter Descriptions (page 187)
5.4.2.1 Get All Parameters
You can use the
G command to view all parameter values if you do not specify any parameters in the command.
G
5.4.2.2 Get Specified Parameters
You can use the
G command to view specified parameter values.
G xx Any parameter in D. Configuration Parameter Descriptions (page 187)
Example
In this example the averaging time is shown to be 4 seconds:
G wndAvgs wndAvg ,3.00000
WMT700 User Guide
M211095EN-H
104


5.4.3 BAUD — Display or Set Port Settings
This command shows or changes values of the serial port settings.


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   43   44   45   46   47   48   49   50   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha