User Guide M211095en-h



Download 8.38 Kb.
View original pdf
Page3/125
Date24.02.2019
Size8.38 Kb.
1   2   3   4   5   6   7   8   9   ...   125
Test
Setup According to
Wind driven rain
MIL-STD G Method Salt fog
IEC 60068-2-52, VDA 621 - Leak test (Ingression Protection)
IEC 60529 class IP67
Vibration
IEC 60068-2-6
Shock
MIL-STD-202G, Method B, cond. J
Dry heat
IEC Damp heat cyclic
IEC Damp heat
IEC Low temperature
IEC Free fall (rough handling)
IEC Change of temperature
IEC Wind tunnel tests have been performed according to Sonic anemometers/thermometers -Acceptance test methods for mean wind measurements ISO 16622:2002 and Measnet
Anemometer Calibration Procedure Version 2, October 2009.
EMC tests are based on a European product family standard EN 61326-1:2013 (Electrical equipment for measurement, control and laboratory use - EMC requirements for use in industrial locations) and EN 60945:2002 (Maritime Navigation and Radiocommunication
Equipment and Systems - General Requirements - Methods of Testing and Required Test
Results).
Table 3 Electromagnetic Compatibility Tests


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   2   3   4   5   6   7   8   9   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha