User Guide M211095en-h



Download 8.38 Kb.
View original pdf
Page22/125
Date24.02.2019
Size8.38 Kb.
1   ...   18   19   20   21   22   23   24   25   ...   125
More Information
‣ Configuration Parameter Descriptions (page Operating WMT700 in WS425 Analog Output Mode (page 128)
3.8.1 Analog Output Types
Analog output for Wind Speed (Aout1) can be configured as:
Voltage output
Current output
Chapter 3 – Functional Description
43

Frequency output
Push-pull output
• Pull-down output
Pull-up output
Analog output for Wind Direction (Aout2) can be configured as:
• Voltage output
• Current output
• Potentiometer output
Figure 19 Frequency Output
WMT700 User Guide
M211095EN-H
44


3.8.2 Analog Output Scaling
You can specify the transfer function between measured values and output analog values.
You can select the analog output type as well as the gain and offset used in the transfer function.
Table 18 Factory Settings for Analog Wind Speed Output


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   18   19   20   21   22   23   24   25   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha