User Guide M211095en-h



Download 8.38 Kb.
View original pdf
Page20/125
Date24.02.2019
Size8.38 Kb.
1   ...   16   17   18   19   20   21   22   23   ...   125
More Information
‣ Command Set for WMT700 (page 181)
3.7.3 Protocols
In addition to the protocols preconfigured under standard profiles, there are additional protocols available:
• WMT700
• WMT700 NMEA MWV
• SDI-12
• WS425 - ASOS
• WS425 - ASCII
• WS425 - NMEA Standard
• WS425 - WAT11
• MES12
More Information
‣ Parameter Handling Commands (page 102)
3.7.4 Measurement and Configuration Modes
The serial ports have two operation modes:
• The configuration mode is for configuring WMT700 settings over a serial connection.
The selected communication profile does not affect the available configuration commands.
• The measurement mode is for operating WMT700. The available commands depend on the selected profile. The port in the measurement mode can receive polling commands and respond to them with data messages.
The following figure shows the configuration and measurement modes of both serial ports provided by WMT700.
Chapter 3 – Functional Description
41

Figure 17 Configuration and Measurement Modes
After power-up, WMT700 is in measurement mode.


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   16   17   18   19   20   21   22   23   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha