User Guide M211095en-h



Download 8.38 Kb.
View original pdf
Page105/125
Date24.02.2019
Size8.38 Kb.
1   ...   101   102   103   104   105   106   107   108   ...   125
Item
Order Code
Adapter for FIX General purpose mounting adapter (suitable also for inverted mounting)
WMT70FIXSP
Plastic mounting adapter for 60 mm tube
WMT700FIX60-POM
Stainless steel mounting adapter for 60 mm tube
WMT700FIX60-RST
WMT700 User Guide
M211095EN-H
178


Item
Order Code
Cross-arm (requires WMT70FIX mounting adapter)
WMT70CROSSARM
ASOS mounting adapter
ASM212140
Table 69 WS425 Mounting Accessories
Item
Order Code
Adapter for WS425FIX30, WS425FIX60-POM, and WS425FIX60-RST
228777
Mounting adapter for 30 mm tube
WS425FIX30
Aluminum mounting adapter for 60 mm tube
WS425FIX60
Sensor support arm for 60 mm pole (655 mm with integrated fix for item
228777)
WAC425
Chapter 8 – Technical Data
179


WMT700 User Guide
M211095EN-H
180

Appendix A. Command Set for
WMT700
The following table lists all the commands available for WMT700.
Table 70 Command Set for WMT700


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Analog outputs for wind direction
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   101   102   103   104   105   106   107   108   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha