User Guide M211095en-h


Analog outputs for wind direction



Download 8.38 Kb.
View original pdf
Page103/125
Date24.02.2019
Size8.38 Kb.
1   ...   99   100   101   102   103   104   105   106   ...   125
Analog outputs for wind direction
Voltage
0 ... 10 V (U = 20 mV/°)
Current
0 ... 20 mA (I = 50 uA/°)
Potentiometer
Reference voltage 1 ... 10 VDC, 0 ... V
ref represents 0 ...
359°
8.3 Environmental Specifications
Table 63 WMT700 Environmental Specifications
Property
Description/Value
Operating temperature ... +60 CFC CC, or ... +70 C (-67 ... +158 °F)
Storage temperature ... +80 C (‑76 ... +176 °F)
Operating humidity ... 100 %RH
IP rating
IP66 and IP67
EMC
IEC 61000-4-2 ... 6
Emissions
CISPR22
Environmental
IEC 60068-2-1,2,6/34, 30, 31, 67, 78, IEC 60529; VDA
621-415
Maritime
DNVGL-CG-0339; Lloyd's Register requirements IEC
60945
Chapter 8 – Technical Data
175


8.4 Mechanical Specifications
Table 64 WMT700 Mechanical Specifications


Document code
Testsetup according to
More information
Optiontemperature range
Optionheating
Optionhardware interface
Optionunit used
Optionoutput configuration
Selectionoutput configuration
Optionadapter type
Optionaccessories
Order codedescription
Aout1 selected option
Output signal
Swnddiroffset,(angle)
Parameterdefinition
Power supplywire colors
Used heating option
Heating option
Wire type/cable length
Descriptionspare part item
Wmt700connector pin
Open commandto activate the command, press enter
Commanddescription
Wind_getfetches wind calibration information.more information
S command. power must be on for at least 5 seconds after the s
Startcommand.more information
Itemdescription
Bitdescription
G command to fetch the current wmt700 parameters. disable error messages with the command s messages,0
Errors. if all values are valid, wmt700 sends the following response:0,0,0,0you can also use the g
Data message number
Ws425 and sdi messages
Parametername
Parameterdefault
Start command.to stop measurement, use the stop
Wb,wfirmware
Wf output:wff6785672109876.5432.1k99xx5.21.2 ws425 f/g asos data messagewmt700 responds to the wa
Bytedescription
Parameterdefault value
Id character
Wx command with a character fixed-length data message.character
Start command. to stop measurement, use thestop
Problemprobable cause
Error/eventcode
Parameter name
Propertydescription/value
Itemorder code
Configuration mode / measurement
Settingparameter
Start command. you can stop the measurement with the stop
Example of the command and response:
Baud........................................................................ 105clearerr
S............................................................................... 103sleep
Gget message. get parameter.........................................................104h
Jjunction box...............................................................28l



Share with your friends:
1   ...   99   100   101   102   103   104   105   106   ...   125


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha