Quadboss atv straight push tube owner’s manual please read this entire



Download 54.18 Kb.
View original pdf
Page1/6
Date02.11.2018
Size54.18 Kb.
  1   2   3   4   5   6


QUADBOSS ATV STRAIGHT PUSH TUBE
OWNER’S MANUAL
Please read this entire
owner’s manual before
assembling or installing
the plow system!
PART #9332
PAGE 1 of 6
This owner’s manual covers all aspects of your new
push tube including assembly, replacement parts,
installation, warranty, and troubleshooting. For any
additional questions or concerns please call
877-847-1558 or visit www.quadboss.com.
06/06/2011
Rev. 1.1
Assembly -
Note: You will need to have the blade assembled before attempting to attach the push tube.
1
2
The Quadboss straight push tube comes completely pre-assembled for your convenience. Seethe instructions below to attach the push tube to the blade. NOTE: The hardware for attaching the push tube to the blade comes with the blade! Figure 1 - Note Hardware shown will be packaged with the blade!
HDW9210
HDW9025
HDW9025
HDW7089
HDW9207
HDW7058
HDW9208 Figure 2
3
Attach each strut from the blade to the welded tabs on the push tube. Secure with ax shoulder bolt (#HDW9208) from the top and a 5/16” nylock nut (#HDW7058) on the bottom. Place the plow system face down on the blade with the push tube up in the air. Move the push tube back and forth to ensure there is no binding in the slide mechanism. Place the plow back on the ground in the normal position and install the pivot pin
(#HDW9207). You can now install the assembled plow onto the ATV.
The push tube will slide into the center of the brackets on the back of the blade. Bolt the push tube to the blade by first sliding the spacer (#9360-112) through the blade and push tube. Secure with the 1/2” x 3-1/2” hex bolt (#HDW9210), 1/2” flat washers (#HDW9025), and 1/2” nylock nut
(#HDW7089). See figure 1. It maybe easier to position the blade face down on the ground and install the push tube vertically into the blade. Tech Line 877-847-1558
www.quadboss.com


QUADBOSS ATV STRAIGHT PUSH TUBE
SAFETY PRECAUTIONS
06/06/2011
Rev. 1.1
PAGE 2 of 6


Part #9332blade warning decal
Proper position of the pivot plate and
Raise the plow so the


Share with your friends:
  1   2   3   4   5   6


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
yamaha