Mac aura xb user manual tm


matches the local AC mains power voltage before applying power to the fixture



Download 448.03 Kb.
View original pdf
Page8/67
Date07.11.2018
Size448.03 Kb.
1   ...   4   5   6   7   8   9   10   11   ...   67
matches the local AC mains power voltage before applying power to the fixture.
The MAC Aura XB has an auto-ranging power supply that accepts AC mains power at 100V
240V, Hz. Do not apply AC mains power at any other voltage or frequency to the fixture.
Power cables and power plug
The MAC Aura XB requires a power input cable that must be ordered separately. The power input cable must have a Neutrik PowerCON True NAC3FX-W cable connector for AC mains power input. The cable must meet the requirements listed under Protection from electric shock on page 3.
Martin™ can supply either suitable 3 m (9.8 ft) power cables with PowerCON True input connectors installed or PowerCON True connectors without cables (see Accessories on page If you need to install a PowerCON True connector on a power cable, seethe instructions from Neutrik that are reproduced at the end of this manual.
The MAC Aura XB can be hardwired to a building electrical installation if you want to install it permanently, or a power plug that is suitable for the local power outlets can be installed on the power cable.
If you install a power plug on the power cable, install a grounding-type (earthed) plug with an integral cable grip that is rated 250 VA minimum. Follow the plug manufacturer’s instructions. Table 1 shows standard wire color-coding schemes and some possible pin identification schemes if pins are not clearly identified, or if you have any doubts about proper installation, consult a qualified electrician.


Mac aura xbuser manual
Warning! risk group 2 led product according to en 62471. do not view the light output with optical
Warning!read the safety precautions in this section before
Control buttons
Using for the first time
Warning! read safety information s
Wire color(eu models)
Tips for reliable data transmission
Connecting the data link
Fastening the fixture to a flat surface
Figure 2: risk of sunlight damage
Suspending the fixture
Quick-mount surface mounting bracket
Figure 3: rigging clamp bolt
Using the control buttons
Personality → display
Beam, aura and fx control
Recommended beam and aura control method
Beam: use channels 1 through beam provides control of all parameters for the main beam and the fx section. aura
Coolingfans
Dimmingdimmer curve
Ext and std
Color wheel priority
Ctc (color temperature control)
Calibrated and raw color output
Color mode →extended
Fx: pre-programmed beam and aura effects
Fx sync and random operation
Sync shiftthe sync shift
Fx priority and overriding
Warning! read safety information on page 3 bef
Control menu service utilities
Service→calibration
Installing software normal method
Display messages
Beam electronic shutter effect
Fixture control settings
Channel dmx
Beam color wheel effect
Aura dimmer0 → 100% intensityfade0channel
Aura color wheel effect
Ext mode only).dmx integer
P/t speedpan and tilt speed normal / fast
Error modenormal
Aura led temp
Pan offsetpan calibrationtilt offset
Beam tmp sen err
Pan fback err
Table 5: display messages
Table 6: troubleshooting
Optics and photometric data
Control and programming
Typical power and current
Accessoriespower cables
Installation hardware
Ordering information
Brouilleur du canada



Share with your friends:
1   ...   4   5   6   7   8   9   10   11   ...   67


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
yamaha