Iq force™ Gas Detector Reference Manual



Download 339.9 Kb.
View original pdf
Page31/87
Date11.05.2019
Size339.9 Kb.
1   ...   27   28   29   30   31   32   33   34   ...   87
2.1 Turning the IQ Force On
To turn the IQ Force on, press and hold the MODE button for one second. The first screen shown will be the test screen for the LCD. All sections should be darkened.
The test screen will be followed by a screen showing the instrument firmware version.
The sensor screen and instrument serial number screen will then be shown.

IQ Force™ Gas Detector Reference Manual
11
Turning the IQ Force On
Next, the following screen will be shown. The time figure in the lower-right corner indicates the datalogging interval in minutes and seconds (the default setting of one minute is shown. In the IQ Force, the standard one-minute sampling interval will result in the ability to store a minimum of 41 hours of readings before the oldest data is overwritten by new data. The sampling interval maybe modified using
BioTrak Software.
The time will then be shown followed by the date:
The instrument will display a moving o as it performs operational checks. During the self-test, the IQ Force tests for installed sensors and performs a system memory check.
For instructions on changing the time and date with the MODE button, see Section 6.4
and Section The instrument temperature will then be shown.

IQ Force™ Gas Detector Reference Manual
12


Iq force™ gas detector
Contacting honeywell analytics
Technical services
Appendix a toxic gas measurement – warning, danger, stel,
Appendix d toxic sensor cross-sensitivity .............................. 52
Operating temperature
Multi-sensor capability
Table 2. alarm logic
Iq force portable gas detectors have been designed for the
In the event of an lel over-range alarm, the iq force must be
A sensor that cannot be calibrated or is found to be out of toler-
Do not use the pump for prolonged periods in an atmosphere
Case: the instrument is enclosed in a solid pc (polycarbonate) case with tpe (rubber) overmold.2. front face:
On/off mode button:
Battery charger connector:
Turning the iq force on
Notethe bump test interval and bump test due reminder are
Notesample probe assembly and tubing must be attached when
Always verify that all sensors present in the instrument are
Turning the iq force off
The iq force is designed to detect potentially life threatening
The iq force must be located in a nonhazardous location during
A combustible sensor over-range alarm indicates a potentially
Pc connection via infrared port
Error messages
Manual sample-draw kit
Motorized sample-draw pump
The canadian standards association (csa) requires the lel
Calibration/accuracy verification
Figure 1. bump test/span calibration setup
Fresh air/zero calibration
Possible causes and solutions
Fresh air/zero calibrations may only be performed in an
Span calibration
Noteonce the calibration cycle is completed, the iq force will
Possible causes of span calibration failure and remedies:
A sensor that cannot be calibrated or is found to be out of
Noteto enable the h
Notehoneywell analytics recommends regular verification of
Notethe bump test interval and bump test reminder are used
Toxic gas measurement – warning, danger, stel, and twa alarms
A.2 time weighted average (twa)
Appendix b calibration frequency rec-
Verification of accuracy & related terminology
Lengthening the intervals between calibration checks or bump tests
One button automatic full calibration and calibration docks
Iq force sensor information



Share with your friends:
1   ...   27   28   29   30   31   32   33   34   ...   87


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha