Iq force™ Gas Detector Reference Manual

Contacting Honeywell Analytics

Download 339.9 Kb.
View original pdf
Size339.9 Kb.
1   2   3   4   5   6   7   8   9   ...   87

Contacting Honeywell Analytics
North America
Honeywell Analytics
405 Barclay Boulevard
Lincolnshire, Illinois, USA Tel +1 847 955 Toll free +1 800 538 Fax +1 847 955 8208
BW Technologies by Honeywell - 2 Avenue SE
Calgary, AB
T2A 7X9
Tel: (403) Fax (403) 273-3708
Latin America and Caribbean
Honeywell Analytics
Av. Marginal da Rodovia dos Bandeirantes, 100
Distrito Industrial - Jundiaí, So Paulo
ZIP: Tel +55 11 Fax +55 11 3309-1005
Europe, Middle East, and Africa
Life Safety Distribution AG
Wilstrasse 11-U11
CH-8610 Uster
Tel: +41 (0)1 943 Fax +41 (0)1 943 4398
Asia Pacific
Honeywell Analytics Asia Pacific, Kolon Science Valley (1)
187-10 Guro-Dong, Guro-Gu
Seoul, 152-729,
Tel: +82 (0)2 6909 Fax +82 (0)2 2025 0328

Iq force™ gas detector
Technical services
Appendix a toxic gas measurement – warning, danger, stel,
Appendix d toxic sensor cross-sensitivity .............................. 52
Operating temperature
Multi-sensor capability
Table 2. alarm logic
Iq force portable gas detectors have been designed for the
In the event of an lel over-range alarm, the iq force must be
A sensor that cannot be calibrated or is found to be out of toler-
Do not use the pump for prolonged periods in an atmosphere
Case: the instrument is enclosed in a solid pc (polycarbonate) case with tpe (rubber) overmold.2. front face:
On/off mode button:
Battery charger connector:
Turning the iq force on
Notethe bump test interval and bump test due reminder are
Notesample probe assembly and tubing must be attached when
Always verify that all sensors present in the instrument are
Turning the iq force off
The iq force is designed to detect potentially life threatening
The iq force must be located in a nonhazardous location during
A combustible sensor over-range alarm indicates a potentially
Pc connection via infrared port
Error messages
Manual sample-draw kit
Motorized sample-draw pump
The canadian standards association (csa) requires the lel
Calibration/accuracy verification
Figure 1. bump test/span calibration setup
Fresh air/zero calibration
Possible causes and solutions
Fresh air/zero calibrations may only be performed in an
Span calibration
Noteonce the calibration cycle is completed, the iq force will
Possible causes of span calibration failure and remedies:
A sensor that cannot be calibrated or is found to be out of
Noteto enable the h
Notehoneywell analytics recommends regular verification of
Notethe bump test interval and bump test reminder are used
Toxic gas measurement – warning, danger, stel, and twa alarms
A.2 time weighted average (twa)
Appendix b calibration frequency rec-
Verification of accuracy & related terminology
Lengthening the intervals between calibration checks or bump tests
One button automatic full calibration and calibration docks
Iq force sensor information

Share with your friends:
1   2   3   4   5   6   7   8   9   ...   87

The database is protected by copyright © 2017
send message

    Main page

Harley Davidson