Iq force™ Gas Detector Reference Manual


WARNINGIQ Force portable gas detectors have been designed for the



Download 339.9 Kb.
View original pdf
Page17/87
Date11.05.2019
Size339.9 Kb.
1   ...   13   14   15   16   17   18   19   20   ...   87
WARNING
IQ Force portable gas detectors have been designed for the
detection of oxygen deficiency or enrichment, accumulations of
flammable gases and vapors, and accumulations of specific toxic
gases. An alarm condition indicating the presence of one or more
of these potentially life-threatening hazards should betaken very
seriously.
In the event of an alarm condition, it is important to follow
established procedures. The safest course of action is to
immediately leave the affected area, and to return only after
further testing determines that the area is once again safe for
entry. Failure to immediately leave the area may result in serious
injury or death.
A rapid upscale reading followed by a declining or erratic
reading may indicate a hazardous combustible gas concentration
that exceeds the IQ Force’s zero to 100 percent LEL detection


Iq force™ gas detector
Contacting honeywell analytics
Technical services
Appendix a toxic gas measurement – warning, danger, stel,
Appendix d toxic sensor cross-sensitivity .............................. 52
Operating temperature
Multi-sensor capability
Table 2. alarm logic
In the event of an lel over-range alarm, the iq force must be
A sensor that cannot be calibrated or is found to be out of toler-
Do not use the pump for prolonged periods in an atmosphere
Case: the instrument is enclosed in a solid pc (polycarbonate) case with tpe (rubber) overmold.2. front face:
On/off mode button:
Battery charger connector:
Turning the iq force on
Notethe bump test interval and bump test due reminder are
Notesample probe assembly and tubing must be attached when
Always verify that all sensors present in the instrument are
Turning the iq force off
The iq force is designed to detect potentially life threatening
The iq force must be located in a nonhazardous location during
A combustible sensor over-range alarm indicates a potentially
Pc connection via infrared port
Error messages
Manual sample-draw kit
Motorized sample-draw pump
The canadian standards association (csa) requires the lel
Calibration/accuracy verification
Figure 1. bump test/span calibration setup
Fresh air/zero calibration
Possible causes and solutions
Fresh air/zero calibrations may only be performed in an
Span calibration
Noteonce the calibration cycle is completed, the iq force will
Possible causes of span calibration failure and remedies:
A sensor that cannot be calibrated or is found to be out of
Noteto enable the h
Notehoneywell analytics recommends regular verification of
Notethe bump test interval and bump test reminder are used
Toxic gas measurement – warning, danger, stel, and twa alarms
A.2 time weighted average (twa)
Appendix b calibration frequency rec-
Verification of accuracy & related terminology
Lengthening the intervals between calibration checks or bump tests
One button automatic full calibration and calibration docks
Iq force sensor information



Share with your friends:
1   ...   13   14   15   16   17   18   19   20   ...   87


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha