Fishman F1 Aura User Guide



Download 46.45 Kb.
View original pdf
Page8/8
Date07.11.2018
Size46.45 Kb.
1   2   3   4   5   6   7   8
O
= Off,
I
= On. Seepage for details on how to use the Anti-Feedback circuit.


14
Edit Mode Controls (cont.)
Image EQ
You can program unique EQ settings for each of the Images. Unlike other Edit mode parameters, unique tone settings are saved with each Image and recalled when an Image is selected. In order to prevent dramatic or unwanted changes, the Image EQ’s Treble, Mid, and Bass controls are separated from the Pickup
EQ and located under the Volume knob in Edit mode. They are identifi ed by a lowercase
t
,
m
,
b
, corresponding to Treble, Mid, and Bass respectively.
To EQ an Image. Adjust the Blend control so that you are hearing 100% Image (page 8)
2. Press Edit knob to enter Edit mode and select an Image. Press the Volume button to select the Image Treble EQ (
t
)
4. Turn the Edit knob to boost or cut the Image Treble EQ
5. Repeat steps 3 & 4 to adjust the Image Mid (
m
) and Image Bass (
b
)


15
Edit Mode Parameters
Pickup Bass EQ
Pickup Mid EQ
Pickup Treble EQ
Image Select
Pickup/Image Blend
Compressor
Anti-Feedback
Image Bass EQ
Image Mid EQ
Image Treble EQ


16
Power
Plug in the guitar, and F Aura switches on. To conserve the battery, remove the instrument cable from the guitar when the system is not in use.
The tuner display will fl ash at power-up to tell you the preamp is on.
Low Battery Indicator
When the tuner fl ashes L once every three seconds, you have approximately
1.5 hours before the battery is exhausted. Change it at the next opportunity.


17
Restore Factory Defaults
1. Press + hold the Edit knob while plugging in the guitar. Continue to hold the Edit knob down when the tuner displays an R. Continue to hold the Edit knob, then press the Volume knob. Release both knobs. Factory reset is complete when the R stops fl ashing and the unit returns to normal operation.
Defaults:
• EQ for all Images reverts to fl at
• Pickup EQ reverts to fl at
• Blend is set to Compressor is set to minimum
• Anti-Feedback frequency is reset to 100Hz
• Image selector reverts to Image #1


18


19
Electrical Specifi cations
Digital Signal Path:
A/D, DA conversion
24-bit
Signal Processing
32-bit
Typical in-use current consumption @ 9VDC:
18mA
Typical V lithium battery life
54 hours
Typical V alkaline battery life
27 hours
Nominal output impedance k Ohm
Recommended load impedance k Ohm and up
Maximum output level (onset of clipping
+5dBV
Baseline noise
-92dBV
Dynamic Range
97dB
Bass control dB @ 70Hz
Midrange control dB @ 1kHz
Treble control dB @ 6.5kHz
All specifi cations subject to change without notice.


www.fi shman.com
513-300-160 Rev A 11-09


User guidef1 aura™
Play mode controls
Play mode controls (cont.)
Edit mode controls
Edit mode controls (cont.)
Compressorthe compressor



Share with your friends:
1   2   3   4   5   6   7   8


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
yamaha