OK. 4) Press OK to select "Date Time. 5) To modify date or time, press to move the cursor to the desired option, and then press ▲/▼ again to enter correct date or time. Press OK to save your settings. Note You can set the date between January stand December st 2032. To set the date beyond this range, you need to consult our commercial representatives or pre-sales technical support engineers. 12
Fingerprint Lock User Manual Vb. Enrollment and Verification 2.1 Enroll an Administrator If the fingerprint lock has no administrator, you must at least enroll one administrator before enrolling ordinary users. To enroll an administrator, proceed as follows 2009-11-24 FP LOCK Menu ↓ User Manage Options PenDrive Mng User Manage ↓ Enroll User FPCard Mng Admin Cnt 1) Power on the fingerprint lock by pressing the Start key to open up the initial interface. Press and hold the Menu key to display the menu interface. 2) Press OK to display the user management interface. 3) Press to select Admin Cnt” and then press OK. After that, the enrolled administrator can perform fingerprint, password and RF card enrollment. 13
Fingerprint Lock User Manual Vb Enroll a Fingerprint 4) Press to select Enroll FP” and then press OK. 5) Press to select Admin Accredit, and then select Supervisor (Super administrator) or Admin (Administrator. Press OK to confirm your selection. 6) Press OK to continue. 7) The system by default assigns unused user IDs from 00001 and you may also manually enter an unused user ID. 8) Press the same finger on the fingerprint sensor three consecutive times by adopting the proper finger placement mode. The system will prompt you to save the enrollment information after you enroll the fingerprint successfully. If enrollment fails, the system will prompt you to re-enroll your fingerprint. Enroll Admin ↓ Enroll FP Enroll Pwd Reg RFID Admin Accredit Supervisor ESC OK Enroll FP New Enroll ESC OK New Enroll UserID 00001 ESC OK 00001-0 Place Finger… ESC This meter is used to indicate the successful fingerprint enrollment times One white bar turns black each time when you enroll a fingerprint successfully. 14
Fingerprint Lock User Manual V The system returns to the New Enroll interface upon successful enrollment. You can continue or exit the fingerprint enrollment. Note: The last digit in “00001–0” refers to the fingerprint count. “0” refers to the first fingerprint, “1” refers to the second fingerprint and soon and so forth.