Part No. MAN, Rev. 1-0809 Work Lights 1. Remove the cover by pulling back the rubber seal around the lamp housing as shown in Figure Pull the bulb out of the rubber seal. Figure 7-38. Pull the cover and bulb out of the rubber seal around the lamp housing. 3. Remove the wire leads from the bulb. 4. Connect the leads to the new bulb and press it back into the rubber seal. 5. Press the cover back into the seal, making sure it is firmly seated to prevent water seepage.
Chapter 8, Parts Lists and Drawings E.H. Wachs Part No. MAN, Rev. 1-0809 135 Chapter 8 Parts Lists and Drawings Refer to the following drawings and component lists to identify part numbers and perform service. D 77-ELEC-A Electrical schematic (pre-September D 77-ELEC-B Electrical schematic (post-September D 77-HYD W-DA Hydraulic schematic (pre-September D 77-HYD W-DB Hydraulic schematic (post-September D 77SWIVEL-PWA Pressure washer schematic (pre-September D 77SWIVEL-PWC Pressure washer schematic (post-September 2007)