E. H. Wachs 600 Knightsbridge Parkway


Part No. MAN, Rev. EH. Wachs



Download 27.99 Kb.
View original pdf
Page93/100
Date24.02.2019
Size27.99 Kb.
1   ...   89   90   91   92   93   94   95   96   ...   100

Part No. MAN, Rev. EH. Wachs
2.
Remove the four screws on the front of the cover.
Figure 7-23. Remove the four screws holding the front
of the sprayer pump belt cover.
3.
Lift the cover up and tip it to remove it from behind the engine.
4.
Inspect the belts for any damage. Check the tension on the belts.
Figure 7-24. Inspect the sprayer pump belts for dam-
age and correct tension.


Chapter 7, Service and Repair Servicing the Drive Belts
E.H. Wachs
Part No. MAN, Rev. 1-0809 125 To replace one or both belts, loosen the lock nuts on the tension screws, and then turn the screws counterclockwise until the belts can slip off the pulleys
Figure 7-25. Loosen the lock nuts, then turn the ten-
sioning screws counterclockwise to loosen the tension
on the belts.
6.
Slip the worn or damaged belt off the pulleys, and replace it with anew belt.
Turn both tensioning screws the same number of turns to keep the sprayer pump square with the drive system.
7.
Tighten the sprayer pump belt tensioning screws until the belts are tight on the pulleys. To check the tension, place your thumb on the belt halfway between the pulleys and press down. The belts should deflect no more than 1/2” (13 mm.
8.
Re-tighten the lock nuts on both tensioning screws
9.
Replace the sprayer pump belt cover and insert the four screws in the front.
10.
Replace the screw in the back of the sprayer pump belt cover.
Lock nuts
Tensioning
screws
NOTE

1   ...   89   90   91   92   93   94   95   96   ...   100


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha