E. H. Wachs 600 Knightsbridge Parkway



Download 27.99 Kb.
View original pdf
Page92/100
Date24.02.2019
Size27.99 Kb.
1   ...   88   89   90   91   92   93   94   95   ...   100
Loosen belts
Tighten belts
Second screw
behind cable


Chapter 7, Service and Repair Servicing the Drive Belts
E.H. Wachs
Part No. MAN, Rev. 1-0809 123 Slip the worn or damaged belt off the pulleys, and replace it with the new belt.
Turn both tensioning screws the same number of turns to keep the blower square with the drive system.
8.
Tighten the blower belt tensioning screws until the belts are tight on the pulleys. To check the tension, place your thumb on the belt halfway between the pulleys and press down. The belts should deflect no more than 1/2” (13 mm).
9.
Replace the blower belt cover and insert the bottom two screws in the front.
10.
Replace the priming tank and bracket and insert the top two screws holding the bracket.
11.
Replace the screw in the back of the blower belt cover.
Sprayer Pump Belts
Move the spoils tank out to the dump position for easier access to the belts.
1.
Remove the screw holding the back of the sprayer pump belt cover.
Figure 7-22. Remove the screw on the back of the
sprayer pump belt cover.
NOTE
NOTE

1   ...   88   89   90   91   92   93   94   95   ...   100


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha