E. H. Wachs 600 Knightsbridge Parkway



Download 27.99 Kb.
View original pdf
Page90/100
Date24.02.2019
Size27.99 Kb.
1   ...   86   87   88   89   90   91   92   93   ...   100

Part No. MAN, Rev. EH. Wachs
S
ERVICING

THE
D
RIVE
B
ELTS
This section describes how to check and replace the drive belts (two each) for the sprayer pump and vacuum blower in addition to procedures for tightening the belts. Belts that are in good condition maybe tightened rather than replaced. Check for cracks, tears, worn surfaces, or signs of overheating when inspecting the belts. Replace any belt that is damaged.
Vacuum Blower Belts
Move the spoils tank out to the dump position for easier access to the belts.
1.
Remove the screw holding the back of the blower belt cover.
Figure 7-17. Remove the screw on the back of the
blower belt cover.
NOTE


Chapter 7, Service and Repair Servicing the Drive Belts
E.H. Wachs
Part No. MAN, Rev. 1-0809 121 Remove the two top screws holding the priming tank bracket.
Figure 7-18. Remove the two top screws holding the
priming tank bracket in place then remove the
bracket and tank.
3.
Remove the bracket and priming tank.
4.
Remove the two bottom screws on the front of the blower belt cover.
Figure 7-19. After removing the priming tank, remove
the two bottom screws in the belt cover.

1   ...   86   87   88   89   90   91   92   93   ...   100


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Harley Davidson
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha