E. H. Wachs 600 Knightsbridge Parkway


Part No. MAN, Rev. EH. Wachs



Download 27.99 Kb.
View original pdf
Page87/100
Date24.02.2019
Size27.99 Kb.
1   ...   83   84   85   86   87   88   89   90   ...   100

Part No. MAN, Rev. EH. Wachs
Figure 7-6. The seal is in the vacuum port. Pry the old
seal out and press the new seal in.
Figure 7-7. Check the seal from the inside of the tank
to ensure that it is properly seated.
R
EPLACING
C
ONTROL
P
ANEL
S
WITCHES
Switches are identified in drawing number D 77-ELEC-
A in Chapter 8. Refer to the drawing to order replacement switches.
Replace damaged switches by taking off the control panel and removing the switches from the back. Turnoff power at the engine keyswitch.
NOTE


Chapter 7, Service and Repair Replacing Control Panel Switches
E.H. Wachs
Part No. MAN, Rev. 1-0809 115 Remove the four screws holding the control panel to the trailer.
Figure 7-8. Remove the four screws at the corners to
take off the control panel.
3.
Carefully tip the control panel down, being sure not to pull off any wires.
Figure 7-9. Components as shown on the back of the
control panel.
Dump switch
Tach/hour meter
Latch switch
Vacuum
gauge
Work light
switch
Vac/pressure
washer switch
Low oil pres-
sure light

1   ...   83   84   85   86   87   88   89   90   ...   100


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha