Part No. MAN, Rev. EH. Wachs Run the vacuum blower when lubricating it to make sure the lubricant reaches all blower components. Alternatively, it maybe easier to spray into the blower when the filter is out of the canister for cleaning. Spray through the airport in the back of the canister. Figure 6-8. To lubricate the blower through the filter canister, spray through the port in the back. 1. When using the lubrication port beneath the blower, remove the plug. 2. When using the airport in the filter canister, remove the filter. 3. Start the engine and run it at medium throttle. 4. At the control panel, turn the Vacuum/Pressure Washer switch to the VAC position. The vacuum blower will engage. Figure 6-9. Turn the Vacuum/Pressure Washer switch to the VAC position. IMPORTANT
Chapter 6, Routine Maintenance Daily Maintenance E.H. Wachs Part No. MAN, Rev. 1-0809 103 Spray lubricant into the blower for 15-30 seconds while the blower is running. 6. At the control panel, turn the Vacuum/Pressure Washer switch to the OFF position. Figure 6-10. Turn the Vacuum/Pressure Washer switch OFF to turnoff the vacuum. 7. If the lubrication port was used, replace the plugin the port. Flip the tab down to lock the plugin place. Figure 6-11. Flip the tab down to lock the plug.