E. H. Wachs 600 Knightsbridge Parkway


Part No. MAN, Rev. EH. Wachs



Download 27.99 Kb.
View original pdf
Page78/100
Date24.02.2019
Size27.99 Kb.
1   ...   74   75   76   77   78   79   80   81   ...   100

Part No. MAN, Rev. EH. Wachs
4.
Unscrew and remove the knob holding the filter element in the canister. Remove the washer on the screw.
Figure 6-4. Remove the knob holding the filter in
place. Be careful not to lose the washer behind the
knob.
5.
Pull the filter out of the canister. Remove the end cover.
The blower can be lubricated through the filter canister while the filter is removed. See Lubricating the Blower below.
Figure 6-5. Remove the filter and takeoff the cover.
6.
Remove the filter element from the holder and replace it with the spare filter.
7.
Put the filter holder back into the canister.
8.
Replace the cover over the end of the filter. Install the washer and the locking knob, securing the knob tightly.
NOTE


Chapter 6, Routine Maintenance Daily Maintenance
E.H. Wachs
Part No. MAN, Rev. 1-0809 101 Close the canister door and fasten it with the three swing latches.
Do not spray the filter element with pressurized water.
High-pressure spray may tear the filter.
10.
Wash the filter that was removed in clean water, or a water/detergent solution. Rinse the filter and set it where it can dry.
Lubricating the Blower
To prevent corrosion, lubricate the blower at the end of the day with a spray lubricant such as WD-40. Apply the spray through the port underneath the blower. Access the port through the accessory storage box under the trailer.
Figure 6-6. Access the blower lubrication port
through the accessory storage box.
Figure 6-7. Flip the tab up to remove the plug for
lubricating the blower.
IMPORTANT

1   ...   74   75   76   77   78   79   80   81   ...   100


The database is protected by copyright ©userg.info 2017
send message

    Main page

bosch
camera
chevrolet
epson
fiat
Honda
iphone
mitsubishi
nissan
Panasonic
Sony
volvo
xiaomi
Xperia
yamaha