Part No. MAN, Rev. EH. Wachs L IGHT B AR O PERATION The light bar controller is mounted in a watertight enclosure on the side of the trailer above the fender. Figure 5-55. The controller for the light bar is inside a watertight enclosure on the side of the trailer. 1. To access the controller, open the enclosure by pulling the top of the front cover forward. Figure 5-56. Pull the top of the enclosure cover for- ward to open it. 2. Press the POWER button to turn on the light bar. 3. At night, push in the NIGHT button for low-intensity light mode.
Chapter 5, Operating Instructions Hydraulic Hose Reel Operation E.H. Wachs Part No. MAN, Rev. 1-0809 81 Set the knob to change the light bar display, as illustrated below. Figure 5-57. Turn the knob on the lightbar controller to set the following modes: WW Wig wag (alternate inside/outside) L Left arrow LS Left arrow solid R Right arrow RS Right arrow solid 5. Close the front cover when not setting the controls. To turnoff the light bar, press the POWER button. H YDRAULIC H OSE R EEL O PERATION VMT-1 trailers with both the hydraulic hose reel and the ERV-750 valve exerciser must share the auxiliary hydraulic circuit. Disconnect the ERV-750 to use the hydraulic hose reel. 1. If necessary, remove the ERV-750 hoses from the auxiliary ports on the front of the hydraulic tank. Cap the hose ends. LEDs mimic lightbar display