CHECK LIST FOR THE OMRON H5S TIME SWITCH 1) Open the bottom flap on the timer. The 3 small switches located on the lower left side should be set in the following order: UP, UP, DOWN. 2) Close flap. 3) The 2 switches located in the lower left hand corner of the face of the timer labeled “out” should be the “Auto” positions. 4) The switch in the lower right hand corner should be in the “Run” position. 5) The time should be on the display at this point. If not then set the time and press the “Write” key. 6) If you do not see the start and stop times on the bottom portion of the screen then the timer must be programmed. PROGRAMMING 1) Slide the lower right hand switch from the “Run” position to the “P1” position. 2) Open the flap located at the bottom of the timer face. 3) Push and hold the small recessed bottom marked “CLR”. 4) Next you have to determine the store hours and days operation. Typically store will run the same hours during the week. For this demonstration we will use the hours Mon-Sat 9-9,Sun 9-4. 5) Push the shift key once to move the arrow over to Mon. push the set/Reset key once .A bar should appear. Push the shift key again to move the arrow over to Tue. Push the Set /Reset key. Repeat this action for the rest of the days of the week except Sun. Note: it is possible to skip a day of operation. Press the shift key once more to advance to another day. 6) Set the turn on time by pressing the “H” key. 7) Set the minutes by pressing the “M” key. 8) Press the “Write” Key. 9) Set the turn off time by pressing the “H” key and the “M” key. Press the write key. 10) There should be a “22” in the lower right hand portion of the display. This indicates that the first 2 programs (24 & 23). Were accepted. 11) To set the timers for Sunday, press the Set/Reset key and a bar will appear under Sunday. 12) Repeat Steps 6,7, & 8. 13) Slide the switch to “Run” position. 14) The green “Off” light should be lit on the Omron H3CR at this time.